After making sure that the hair of the system is not on or near the surface you cleaned, take the MACO Extreme Bond glue and VERY CAREFULLY apply it to the surface of the System.
How to open it:
This cola has a brush. Open it, lift the brush and wait until it drains well. (See photo number 1).
Then, with peripheral movements, try to reduce the amount of glue on the brush, leaving it on the "neck" of the bottle. (See photo number 2).
How to apply it:
After making sure you have drained the cola thoroughly and removed the fibers , begin to slowly spread it over the surface of the front line. Start from the back and leave the ends for last. (See photo number 3).
WHAT NOT TO DO:
Don't try to spread too much cola on the System. Dip and drain the brush several times and patiently. Try to spread the cola evenly.
WHEN YOU REACH THE EDGES:
When you get to the edges you will have to change the way you spread. At the edges, make sure to dab the brush on the System. This way you will reduce the chance of hair sticking. You should put very little cola on the edges. (See photo number 4).
ATTENTION: The cola should not under any circumstances touch the hair of the system, so be very careful.