Take MACO Hair Keratin, spray the hair of the second System (about 10 sprays) and comb it with a brush, slightly backwards. CAUTION make sure you do not get the back of the System base wet.
Take the MACO Cleansing Lotion and some kitchen paper, spray the back of the System base and clean it with the paper.
Place the second system on the head and make sure the front line starts exactly at the mark you made.
Check the right and left corners (at the temples) and make sure that with a little pull they press right where your normal hair starts. If the system is correctly placed in the front and side corners, nothing can go wrong.
Insert your fingers and feel around the system to make sure it is properly seated. If necessary repeat until you are sure it is not wrong.
Hold the back of the System with one hand and with the other lift the front a little more than the first front tape. Remove one tape and stick the first side point. This will free both your hands and the system will not be able to leave its position.
After doing this, check the angles again. Lift the system from one corner and remove ONLY the first tape.
Stick right where the hair starts. The more accurate you are, the better application you will make.
Now lift the system from the other corner and remove the first tape.
Stick as before exactly where the hair starts.
Our two corners are stuck and now we move to the final stage:
After you have glued the system from the front, now you have to lift it from the back to the front, until the point where the first tapes that you glued earlier start.
Peel off all the tapes from the system and from the skin, grasp the edges of the system firmly and roll down until the whole system is stuck.
After sticking the System, take a towel, spread it on the head and pull its edges until the system sticks well.